Table of Contents
Advertisement
28
601
Example 2. The following is sample output from the show ipv6 route command
when IPv6 Routing is enabled and the command is entered without an IPv6
address or prefix specified and IPv6 Routing is enabled:
switchxxxxxx#
show ipv6 route
Codes: > - Best
S - Static, C - Connected,
L - Local(on-link prefixes defined by the ipv6 nd prefix command with on-link
keyword,
[d/m]: d - route's distance, m - route's metric
IPv6 Policy Routing
VLAN 1
Route Map: BPR1
Status: Active
ACL Name: ACLTCPHTTP
Next Hop:
fe80::77
Next Hop Status: Active
ACL Name: ACLTCPTELNET
Next Hop:
4001::27
Next Hop Status: Not Active (Unreachable)
ACL Name: ACL_AA
Next Hop: 301a:23:24
Next Hop Status: Not Active (Not direct)
VLAN 100
Route Map: BPR_10
Status: Not Active (No IP interface on VLAN 100)
ACL Name: ACLTCPHTTP
Next Hop: 4214::10
Next Hop Status: Active
VLAN 110
Route Map: BPR_20
Status: Not Active (VLAN 110 status is DOWN)
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
IPv6 Commands
Advertisement
Table of Contents
