Table of Contents
Advertisement
36
Link Layer Discovery Protocol (LLDP) Commands
switchxxxxxx(config-if)#
lldp transmit
36.22 lldp tx-delay
To set the delay between successive LLDP frame transmissions initiated by
value/status changes in the LLDP local systems MIB, use the lldp tx-delay Global
Configuration mode command. To restore the default configuration, use the no
form of this command.
Syntax
seconds
lldp tx-delay
no lldp tx-delay
Parameters
seconds
tx-delay
—Specifies the delay in seconds between successive LLDP
frame transmissions initiated by value/status changes in the LLDP local systems
MIB (range: 1-8192 seconds).
Default Configuration
The default LLDP frame transmission delay is 2 seconds.
Command Mode
Global Configuration mode
User Guidelines
It is recommended that the tx-delay be less than 25% of the LLDP timer interval.
Example
The following example sets the LLDP transmission delay to 10 seconds.
switchxxxxxx(config)#
lldp tx-delay 10
781
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Advertisement
Table of Contents
