Table of Contents
Advertisement
Ethernet Configuration Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Example
The following example sets the error recovery timeout interval to 10 minutes.
switchxxxxxx(config)#
17.18 errdisable recovery reset
To reactivate one or more interfaces that were shut down by a given application,
use the errdisable recovery reset Privileged EXEC mode command. A single
interface, multiple interfaces or all interfaces can be specified.
Syntax
errdisable recovery reset {all | port-security | dot1x-src-address | acl-deny
| s tp-bpdu-guard | loopback-detection | udld | storm-control | link-flap | interface
interface-id
}
Parameters
•
all—Reactivate all interfaces regardless of their state.
•
port-security—Reactivate all interfaces in the Port Security Err-Disable
state.
•
dot1x-src-address—Reactivate all interfaces in the 802.1x Err-Disable state.
•
acl-deny—Reactivate all interfaces in the ACL Deny Err-Disable state.
•
stp-bpdu-guard—Reactivate all interfaces in the STP BPDU Guard
Err-Disable state.
•
loopback-detection—Reactivate all interfaces in the Loopback Detection
Err-Disable state.
•
udld—Reactivate all interfaces in the UDLD Shutdown state.
•
storm-control—Reactivate all interfaces in the Storm Control Shutdown
state.
•
link-flap—Reactivate all interfaces in the link-flap prevention Err-Disable
state.
•
interface-id—
interface
active, but were shut down by the system.
errdisable recovery interval 600
Reactivate interfaces that were configured to be
17
398
Advertisement
Table of Contents
