Table of Contents
Advertisement
18
425
switchxxxxxx(config)#
flash://web-dictionaries/germany-dictionary.dat
18.5 boot system
To install the system (active) image that the switch loads at startup, use the boot
system command in Privileged EXEC mode.
Syntax
image-url
boot system
boot system inactive-image
Parameters
•
image-url
—The URL of a file. The predefined URLs cannot be configured.
Default Configuration
No default.
Command Mode
Privileged EXEC mode
User Guidelines
Use the boot system
image-url
file. The command performs the following actions:
•
Copies the file into the system directory flash://system/image/
•
Validates its format. If the file does not have the correct image format the file
is deleted and the command is finished with an error.
•
Installs the copied file as the active image that will be used be loaded at
startup. The previous active image file is save as inactive image. The
previous inactive image is deleted.
Use the boot system inactive-image command to set the inactive image as active
one and the active image as inactive one.
Use the
show bootvar / show version
active and inactive images.
boot localization
image-url
command to install a new active image from the
command to display information about the
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
File System Commands
Advertisement
Table of Contents
