Table of Contents
Advertisement
MLD Proxy Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
41.0
41.1 ipv6 mld-proxy
To add downstream interfaces to a MLD proxy tree, use the ip mld-proxy
command in Interface Configuration mode. To remove downstream from
interfaces to a MLD proxy tree, use the no form of this command.
Syntax
upstream-interface-id
ipv6 mld-proxy
no ipv6 mld-proxy
Parameters
•
upstream-interface-id
Default Configuration
The protocol is disabled on the interface.
Command Mode
Interface Configuration mode
User Guidelines
Use the ipv6 mld-proxy command to add a downstream interface to a MLD proxy
tree. If the proxy tree does not exist it is created.
Use the no format of the command to remove the downstream interface. When the
last downstream interface is removed from the proxy tree it is deleted too.
Examples
Example 1. The following example adds a downstream interface to a MLD Proxy
process with vlan 200 as its Upstream interface:
switchxxxxxx(config)#
—Upstream Interface identifier.
interface vlan 100
41
835
Advertisement
Table of Contents
