Table of Contents
Advertisement
Spanning-Tree Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
no spanning-tree priority
Parameters
priority—Specifies the bridge priority. (Range: 0–61440)
Default Configuration
Default priority = 32768.
Command Mode
Global Configuration mode
User Guidelines
The priority value must be a multiple of 4096.
The switch with the lowest priority is the root of the spanning tree. When more
than one switch has the lowest priority, the switch with the lowest MAC address is
selected as the root.
Example
The following example configures the spanning-tree priority to 12288.
switchxxxxxx(config)#
58.7 spanning-tree disable
Use the spanning-tree disable Interface (Ethernet, Port Channel) Configuration
mode command to disable the spanning tree on a specific port. Use the no form of
this command to enable the spanning tree on a port.
Syntax
spanning-tree disable
no spanning-tree disable
Parameters
N/A
spanning-tree priority
12288
58
1106
Advertisement
Table of Contents
