Table of Contents
Advertisement
33
743
33.2 tunnel isatap solicitation-interval
To set the time interval between unsolicited router solicitation messages, use the
tunnel isatap solicitation-interval command in Global Configuration mode. To
restore the default configuration, use the no form of this command.
Syntax
tunnel isatap solicitation-interval
no tunnel isatap solicitation-interval
Parameters
•
seconds
—Specifies the time interval in seconds between ISATAP router
solicitation messages. (Range: 10–3600).
Default Configuration
The default time interval between ISATAP router solicitation messages is 10
seconds.
Command Mode
Global Configuration mode
User Guidelines
This command determines the interval between unsolicited router solicitation
messages sent to discovery an ISATAP router.
Example
The following example sets the time interval between ISATAP router solicitation
messages to 30 seconds.
switchxxxxxx(config)#
33.3 tunnel isatap robustness
To configure the number of router solicitation refresh messages that the device
sends, use the tunnel isatap robustness command in Global Configuration mode.
To restore the default configuration, use the no form of this command.
seconds
tunnel isatap solicitation-interval
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
IPv6 Tunnel Commands
30
Advertisement
Table of Contents
