Table of Contents
Advertisement
Ethernet Configuration Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Default Configuration
If capability is unspecified, defaults to list of all the capabilities of the port and
preferred slave mode.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Example
The following example enables auto-negotiation on gi11.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
17.9 flowcontrol
To configure the Flow Control on a given interface, use the flowcontrol Interface
(Ethernet, Port Channel) Configuration mode command. To disable Flow Control,
use the no form of this command.
Syntax
{auto | on | off}
flowcontrol
no flowcontrol
Parameters
•
auto—Specifies auto-negotiation of Flow Control.
•
on—Enables Flow Control.
•
off—Disables Flow Control.
Default Configuration
Flow control is Disabled.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
interface gi11
negotiation
17
390
Advertisement
Table of Contents
