Table of Contents
Advertisement
17
Ethernet Configuration Commands
Syntax
port jumbo-frame
no port jumbo-frame
Parameters
This command has no arguments or keywords
.
Default Configuration
Jumbo frames are disabled on the device.
Command Mode
Global Configuration mode
User Guidelines
This command takes effect only after resetting the device.
Example
The following example enables jumbo frames on the device.
switchxxxxxx(config)#
port jumbo-frame
17.13 link-flap prevention
To enable setting a physical interface to err-disable state due to excessive link
flapping, use the link-flap prevention Global Configuration mode command. Use
the no form of this command to restore the default configuration.
Syntax
link-flap prevention {enable | disable}
no link-flap prevention
Parameters
enable—Enables Link-flap Prevention.
393
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Advertisement
Table of Contents
