Table of Contents
Advertisement
Quality of Service (QoS) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Example 2. The following example displays the parameters of the aggregate
Two-rate Three-color policer called Policer1.
switchxxxxxx#
show qos aggregate-policer
aggregate-policer policer1 124000 9600 exceed-action policed-dscp-transmit
peak 200000 19200 violate-action policed-dscp-transmit
not used by any policy map
47.18 police aggregate
Use the police aggregate Policy-map Class Configuration mode. command to
apply an aggregate policer to multiple class maps within the same policy map.
Use the no form of this command to remove an existing aggregate policer from a
policy map.
This command is only available in QoS advanced mode.
Syntax
aggregate-policer-name
police aggregate
no police aggregate
Parameters
aggregate-policer-name—Specifies the aggregate policer name. (Length: 1–32
characters)
Command Mode
Policy-map Class Configuration mode.
User Guidelines
An aggregate policer can be applied to multiple classes in the same policy map.
An aggregate policer cannot be applied across multiple policy maps or interfaces.
Use the exit command to return to the Configuration mode. Use the end command
to return to the Privileged EXEC mode.
.
aggregate-policer-name
policer1
47
938
Advertisement
Table of Contents
