Table of Contents
Advertisement
Route Map Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
53.0
53.1 match ip address (Policy Routing)
To match IP packets to perform IP policy routing, use the match ip address
command in Route Map Configuration Mode. To move the match ip address entry,
use the no form of this command.
Syntax
match ip address access-list
no match ip address access-list
Parameters
•
extended-access-list-name
access-list
Default Configuration
No the command is configured.
Command Mode
Route Map Configuration Mode
User Guidelines
The match ip address command allows you to policy route IP packets based on
criteria that can be matched with an extended IP access list; for example, a
protocol, protocol service, and source or destination IP address.
The ACL list specified by the
contain the following keywords:
•
time-range
•
disable-port
•
log-input
extended-access-list-name
—Specifies an extended IP ACL.
extended-access-list-name
53
argument cannot
1033
Advertisement
Table of Contents
