Table of Contents
Advertisement
57
1091
from VLAN 100. The destination session defines VLAN 2 as the RSPAN VLAN and
port
1 as the reflector port
gi1
switchxxxxxx(config)#
switchxxxxxx(config)#
switchxxxxxx(config)#
gi11 network
Example 4. The following example configures a final RSPAN session that copies
traffic from a RSPAN VLAN 2 to destination port
switchxxxxxx(config)#
switchxxxxxx(config-vlan)#
switchxxxxxx(config-vlan)#
switchxxxxxx(config)#
switchxxxxxx(config)#
57.2 monitor session source
To create a new Switched Port Analyzer (SPAN) or Remote SPAN (RSPAN) source
session, use the monitor session source command in Global Configuration mode.
To remove a source session, use the no form of the command.
Syntax
session_number
monitor session
vlan-id
} | {remote vlan
session_number
no monitor session [
vlan-id
| {remote vlan
}]
Parameters
•
session_number
RSPAN session. The range is 1 to 7.
monitor session 1 source interface gi12 both
monitor session 1 source vlan 100
monitor session 1 destination remote vlan 2 reflector-port
vlan 2
remote-span
exit
monitor session 1 source remote vlan 2
monitor session 1 destination interface gi11
source {interface
vlan-id
}
] source [{interface
—Specify the session number identified with the SPAN or
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
SPAN and RSPAN Commands
1:
gi1
interface-id
[both | rx | tx]} | {vlan
interface-id
} | {vlan
vlan-id
}
Advertisement
Table of Contents
