Configuring Rspan Source Session - Cisco NCS 4200 Series Configuration Manual
Layer 2
Hide thumbs
Also See for NCS 4200 Series:
- Configuration manual (66 pages) ,
- Configuration manuals (30 pages) ,
- Configuration manual (36 pages)
Table of Contents
Advertisement
Configuring Switched Port Analyzer
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
no monitor session session-number
Example:
Router(config)# no monitor session 2
Configuring RSPAN Source Session
To configure the source for a RSPAN session:
SUMMARY STEPS
1. enable
2. configure terminal
3. monitor session RSPAN_source_session_number type rspan-source
4. source {single_interface slot/subslot/port| single_vlan [rx | tx | both]
5. destination remote vlan rspan_vlan_ID
6. no shutdown
7. end
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Clears existing SPAN configuration for a session.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Layer 2 Configuration Guide for Cisco NCS 4200 Series
Configuring RSPAN Source Session
17
Advertisement
Table of Contents
