Table of Contents
Advertisement
Quality of Service (QoS) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Example
The following example creates an ACL, places it into a class map, places the class
map into a policy map and sets the DSCP value in the packet to 56 for classes in
the policy map called p1.
switchxxxxxx(config)# ip access-list extended ip1
switchxxxxxx(config-ip-al)# permit ip any any
switchxxxxxx(config-ip-al)# exit
switchxxxxxx(config)# class-map c1
switchxxxxxx(config-cmap)# match access-group ip1
switchxxxxxx(config-cmap)# exit
switchxxxxxx(config)# policy-map p1
switchxxxxxx(config-pmap)# class c1
switchxxxxxx(config-pmap-c)# set dscp
47.12 redirect
Use the redirect Policy-map Class Configuration mode. command to redirect a
traffic flow to a given Ethernet port or port channel.
Syntax
interface-id
redirect
no redirect
Parameters
•
interface-id
—Specifies an Ethernet port or port channel to which the flow is
redirected.
Command Mode
Policy-map Class Configuration mode.
User Guidelines
Use the redirect command to redirect a frame into the VLAN the frame was
assigned to.
56
47
928
Advertisement
Table of Contents
