Table of Contents
Advertisement
41
839
Use the no ipv6 mld-proxy ssm command to remove all defined ranges.
Example
The following example shows how to configure SSM service for the default IPv6
address range and the IPv6 address ranges defined by access lists list1:
switchxxxxxx(config)#
switchxxxxxx(config)#
switchxxxxxx(config)#
switchxxxxxx(config)#
41.5 show ipv6 mld-proxy interface
To display information about interfaces configured for MLD Proxy, use the show
ipv6 mld-proxy interface command in User EXEC mode or Privileged EXEC mode.
Syntax
show ipv6 mld-proxy interface [
Parameters
•
interface-id
—(Optional) Display MLD Proxy information about the interface.
Command Mode
User EXEC mode
Privileged EXEC mode
User Guidelines
The show ipv6 mld-proxy interface command is used to display all interfaces
where the MLD Proxy is enabled or to display the MLD Proxy configuration for a
given interface.
Examples
Example 1. The following example displays MLD Proxy status on all interfaces
where the MLD Proxy is enabled:
switchxxxxxx#
show ip mld-proxy interface
ipv6 access-list list1 permit FF7E:1220:2001:DB8::/64
ipv6 access-list list1 deny FF7E:1220:2001:DB1::1
ipv6 access-list list1 permit FF7E:1220:2001:DB1::/64
ipv6 pim mld-proxy range list1
interface-id
]
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
MLD Proxy Commands
Advertisement
Table of Contents
