Table of Contents
Advertisement
17
391
User Guidelines
Use the negotiation command to enable flow control auto.
Example
The following example enables Flow Control on port gi11
switchxxxxxx(config)#
switchxxxxxx(config-if)#
17.10 mdix
To enable cable crossover on a given interface, use the mdix Interface (Ethernet)
Configuration mode command. To disable cable crossover, use the no form of this
command.
Syntax
{on | auto}
mdix
no mdix
Parameters
•
on—Enables manual MDIX.
•
auto—Enables automatic MDI/MDIX.
Default Configuration
The default setting is Auto.
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example enables automatic crossover on port gi11.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
interface gi11
flowcontrol on
interface gi11
mdix auto
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Ethernet Configuration Commands
Advertisement
Table of Contents
