Table of Contents
Advertisement
802.1X Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
User Guidelines
This command is relevant if the guest VLAN is enabled on the port. Configuring the
timeout adds a delay from enabling 802.1X (or port up) to the time the device adds
the port to the guest VLAN.
Example
The following example sets the delay between enabling 802.1X and adding a port
to a guest VLAN to 60 seconds.
switchxxxxxx(config)#
3.10 dot1x host-mode
To allow a single host (client) or multiple hosts on an IEEE 802.1X-authorized port,
use the dot1x host-mode command in Interface Configuration mode. To restore the
default configuration, use the no form of this command.
Syntax
dot1x host-mode {multi-host
Parameters
•
multi-host—Enable multiple-hosts mode.
•
single-host—Enable single-hosts mode.
•
multi-sessions—Enable multiple-sessions mode.
Default Configuration
Default mode is multi-host.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
Single-Host Mode
dot1x guest-vlan timeout
|
|
single-host
multi-sessions}
60
3
90
Advertisement
Table of Contents
