Dot1X Host-Mode - Cisco 300 Series Cli Manual

Stackable managed switches

Hide thumbs Also See for 300 Series:

Table of Contents

802. 1 X Commands

OL-32830-01 Command Line Interface Reference Guide

—Specifies the time delay in seconds between enabling 802.1X (or

port up) and adding the port to the guest VLAN. (Range: 30–180).

Default Configuration

The guest VLAN is applied immediately.

Command Mode

Global Configuration mode

User Guidelines

This command is relevant if the guest VLAN is enabled on the port. Configuring the

timeout adds a delay from enabling 802.1X (or port up) to the time the device adds

the port to the guest VLAN.

The following example sets the delay between enabling 802.1X and adding a port

to a guest VLAN to 60 seconds.

switchxxxxxx(config)#

dot1x host-mode

Use the dot1x host-mode Interface Configuration mode command to allow a single

host (client) or multiple hosts on an IEEE 802.1X-authorized port. Use the no form of

this command to return to the default setting.

dot1x host-mode {multi-host

multi-host—Enable multiple-hosts mode.

single-host—Enable single-hosts mode.

multi-sessions—Enable multiple-sessions mode.

dot1x guest-vlan timeout

multi-sessions}