Lldp Med Fast-Start Repeat-Count; Lldp Med Location - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
30
Link Layer Discovery Protocol (LLDP) Commands
30.8 lldp med fast-start repeat-count
When a port comes up, LLDP can send packets more quickly than usual using its
fast-start mechanism.
To configure the number of packets that is sent during the activation of the fast
start mechanism, use the lldp med fast-start repeat-count Global Configuration
mode command. To return to default, use the no form of this command.
Syntax
number
lldp med fast-start repeat-count
no lldp med fast-start repeat-count
Parameters
number
repeat-count
—Specifies the number of times the fast start LLDPDU is
being sent during the activation of the fast start mechanism. The range is 1-10.
Default Configuration
3
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)#
lldp med fast-start repeat-count 4
30.9 lldp med location
To configure the location information for the LLDP Media Endpoint Discovery
(MED) for a port, use the lldp med location Interface (Ethernet) Configuration mode
command. To delete location information for a port, use the no form of this
command.
Syntax
{{coordinate data} | {civic-address data} | {ecs-elin data}}
lldp med location
{coordinate | civic-address | ecs-elin}
no lldp med location
651
OL-32830-01 Command Line Interface Reference Guide
Advertisement
Table of Contents
