Show Interfaces Protected-Ports - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
56
1059
no switchport protected-port
Parameters
N/A
Default Configuration
Unprotected
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
Note that packets are subject to all filtering rules and Filtering Database (FDB)
decisions.
Use this command to isolate Unicast, Multicast, and Broadcast traffic at Layer 2
from other protected ports (that are not associated with the same community as
the ingress interface) on the same switch. Please note that the packet is still
subject to FDB decision and to all filtering rules.
Use the
switchport community
interface with a community.
Example
switchxxxxxx(config)#
switchxxxxxx(config-if)#
56.10 show interfaces protected-ports
Use the show interfaces protected-ports EXEC mode command to display
protected ports configuration.
Syntax
show interfaces protected-ports [
Parameters
•
interface-id
—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port or port-channel.
Virtual Local Area Network (VLAN) Commands
Interface Configuration command to associate the
interface gi11
switchport protected-port
interface-id
OL-32830-01 Command Line Interface Reference Guide
| detailed]
Advertisement
Table of Contents
