Show System Router Resources - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
42
815
Setting the new configuration of route entries requires saving the
running-configuration file to startup-configuration file and rebooting the
system, do you want to continue? (Y/N) [N] Y
Example 2
The following example defines the supported number of IPv4 and IPv6 routing
entries. In the example, the configured router entries are less than the router
entries which are currently in use. Using this configurations means that the system
will not have enough resources for the running again in the existing network:
switchxxxxxx(config)#
The maximal number of IPv4 and IPv6 Routing Entries plus non-IP Entries is 2048.
IPv4 Entries
Number of Routes
Number of Neighbors
Number of Interfaces
Non-IP Entries:
- Unit 1
- Unit 2
- Unit 5
The new configuration of route entries is less than the route entries which are
currently in use by the system, do you want to continue (note that setting the new
configuration of route entries requires saving the running-configuration file to
startup-configuration file and rebooting the system)? (Y/N) [N] Y
42.2 show system router resources
To display router resources, use the show system router resources command in
User EXEC mode.
Syntax
show system router resources
system router resources ip-routes 128 ipv6-routes 32
In-Use
Reserved (Current)
------
------------------
232
20
12
100
OL-32830-01 Command Line Interface Reference Guide
Router Resources Commands
Reserved (New)
--------------
1024
128
93%
94%
90%
400
400
400
Advertisement
Table of Contents
