Show Interfaces Counters - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
18
409
18.22 show interfaces counters
To display traffic seen by all the physical interfaces or by a specific interface, use
the show interfaces counters Privileged EXEC mode command.
Syntax
show interfaces counters
Parameters
•
interface-id—(Optional) Specifies an interface ID. The interface ID can be
one of the following types: Ethernet port or port-channel.
•
detailed—(Optional) Displays information for non-present ports in addition
to present ports.
Default Configuration
Display counters for all interfaces. If detailed is not used, only present ports are
displayed.
Command Mode
Privileged EXEC mode
Example
The following example displays traffic seen by all the physical interfaces.
switchxxxxxx#
show interfaces counters gi11
Port
InUcastPkts
---------- ------------ ------------ ------------ ------------
gi11
0
Port
OutUcastPkts OutMcastPkts OutBcastPkts
---------- ------------ ------------ ------------ ------------
gi11
0
Alignment Errors: 0
FCS Errors: 0
Single Collision Frames: 0
[interface-id | detailed
InMcastPkts
InBcastPkts
0
0
1
35
OL-32830-01 Command Line Interface Reference Guide
Ethernet Configuration Commands
]
InOctets
0
OutOctets
7051
Advertisement
Table of Contents
