Errdisable Recovery Cause - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
18
401
18.15 errdisable recovery cause
To enable automatic re-activation of an interface after an Err-Disable shutdown,
use the errdisable recovery cause Global Configuration mode command. To
disable automatic re-activation, use the no form of this command.
Syntax
errdisable recovery cause {all | port-security | dot1x-src-address | acl-deny |
stp-bpdu-guard | loopback-detection | udld }
no errdisable recovery cause {all | port-security | dot1x-src-address | acl-deny |
stp-bpdu-guard | loopback-detection | udld }
Parameters
•
all—Enables the error recovery mechanism for all reasons described below.
•
port-security—Enables the error recovery mechanism for the port security
Err-Disable state.
•
dot1x-src-address—Enables the error recovery mechanism for the 802.1x
Err-Disable state.
•
acl-deny—Enables the error recovery mechanism for the ACL Deny
Err-Disable state.
•
stp-bpdu-guard—Enables the error recovery mechanism for thee STP
BPDU Guard Err-Disable state.
•
loopback-detection—Enables the error recovery mechanism for the
Loopback Detection Err-Disable state.
•
udld—Enables the error recovery mechanism for the UDLD Shutdown state.
Default Configuration
Automatic re-activation is disabled.
Command Mode
Global Configuration mode
Ethernet Configuration Commands
OL-32830-01 Command Line Interface Reference Guide
Advertisement
Table of Contents
