Cisco 300 Series Cli Manual page 113

Stackable managed switches

Hide thumbs Also See for 300 Series:

Table of Contents

igmp {any | source source-wildcard} {any | destination

destination-wildcard}[igmp-type] [dscp number | precedence number] [

time-range-name]

{any | source source-wildcard} {any| s ource-port/port-range}{any |

no permit tcp

destination destination-wildcard} {any| d estination-port/port-range} [dscp number |

precedence number] [match-all list-of-flags] [

{any | source source-wildcard} {any| s ource-port/port-range} {any |

no permit udp

destination destination-wildcard} {any| d estination-port/port-range} [dscp number |

precedence number] [

protocol names are: icmp, igmp, ip, tcp, egp, igp, udp, hmp, rdp, idpr, ipv6,

ipv6:rout, ipv6:frag, idrp, rsvp, gre, esp, ah, ipv6:icmp, eigrp, ospf, ipinip, pim,

l2tp, isis. To match any protocol, use the ip keyword.(Range: 0–255)

—Source IP address of the packet.

source-wildcard

ones in the bit position that you want to be ignored.

—Destination IP address of the packet.

destination-wildcard

address. Use ones in the bit position that you want to be ignored.

- Specify the priority of the access control entry (ACE) in the access

control list (ACL). "1" value represents the highest priority and "2147483647"

number represents the lowest priority.(Range: 1-2147483647)

—Specifies the DSCP value.

—Specifies an ICMP message type for filtering ICMP packets.

Enter a number or one of the following values: echo-reply,

destination-unreachable, source-quench, redirect, alternate-host-address,

echo-request, router-advertisement, router-solicitation, time-exceeded,

parameter-problem, timestamp, timestamp-reply, information-request,

time-range-name]

—The name or the number of an IP protocol. Available

—Wildcard bits to be applied to the source IP address. Use

—Wildcard bits to be applied to the destination IP

—Specifies the IP precedence value.

OL-32830-01 Command Line Interface Reference Guide

time-range-name]

ACL Commands