Cisco 300 Series Cli Manual page 223
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
8
223
Ethernet gi13 is down
Example 4 - In this example, CDP is globally enabled and enabled on the port,
which is up and information is displayed.
switchxxxxxx#
show cdp tlv interface gi11
cdp globally is enabled
Capability Codes: R - Router,T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater,
P - VoIP Phone,M - Remotely-Managed Device,
C - CAST Phone Port, W - Two-Port MAC Relay
Interface TLV: gi11
CDP is enabled
Ethernet gi11 is up,
Device ID TLV: type is MAC address; Value is 00:11:22:22:33:33:44:44
Address TLV: IPv4:
1.2.2.2 IPv6:
Port_ID TLV: gi11
Capabilities: S, I
Version TLV: 1 and 2
Platform TLV: VSD Ardd
Native VLAN TLV: 1
Full/Half Duplex TLV: full-duplex
Appliance VLAN_ID TLV: Appliance-ID is 1; VLAN-ID is 100
COS for Untrusted Ports TLV: 1
sysName: a-switch
Power Available TLV: Request-ID is 1 Power management-ID is 1;
Example 5 - In this example, CDP is globally enabled, and no ports are specified,
so information is displayed for all ports on which CDP is enabled who are up.
switchxxxxxx#
show cdp tlv interface
Available-Power is 10;
Management-Power-Level is 0xFFFFFFFF
OL-32830-01 Command Line Interface Reference Guide
CDP Commands
Advertisement
Table of Contents
