Show Ipv6 Dhcp Guard - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
IPv6 First Hop Security
OL-32830-01 Command Line Interface Reference Guide
Command Mode
ND inspection Policy Configuration mode
User Guidelines
If this command is part of a policy attached to a VLAN, it is applied to all the ports
in the VLAN. If it is defined in a policy attached to a port in the VLAN, this value
overrides the value in the policy attached to the VLAN.
This command has no effect if dropping of unsecured messages is disabled.
Example
The following example defines an NDP Inspection policy named policy1, places
the switch in ND Inspection Policy Configuration mode, and specifies 2 as the
minimum CGA security level:
switchxxxxxx(config)#
switchxxxxxx(config-nd-inspection)#
switchxxxxxx(config-nd-inspection)# exit
25.64 show ipv6 dhcp guard
To display DHCPv6 Guard global configuration, use the show ipv6 dhcp guard
command in Privilege EXEC configuration mode.
Syntax
show ipv6 dhcp guard
Parameters
N/A
Command Mode
Privileged EXEC mode
User Guidelines
The show ipv6 dhcp guard command displays DHCPv6 Guard global
configuration.
ipv6 nd inspection policy policy1
sec-level minimum 2
25
570
Advertisement
Table of Contents
