Police - Cisco 300 Series Cli Manual

Stackable managed switches

Hide thumbs Also See for 300 Series:

Table of Contents

Quality of Service (QoS) Commands

OL-32830-01 Command Line Interface Reference Guide

switchxxxxxx(config-cmap)# match access-group ip1

switchxxxxxx(config-cmap)# exit

switchxxxxxx(config)# policy-map p1

switchxxxxxx(config-pmap)# class c1

switchxxxxxx(config-pmap-c)# set dscp

39.12 police

Use the police Policy-map Class Configuration mode. command to define the

policer for classified traffic. This defines another group of actions for the policy

map (per class map). Use the no form of this command to remove a policer.

committed-rate-kbps committed-burst-byte

committed-rate-kbps

second (bps).(Range 100–10000000)

committed-burst-byte

(Range: 3000–19173960)

exceed-action—Specifies the action taken when the committed rate is

exceeded. If the keyword is not configured then the drop action is applied.

—Specifies the action taken when the committed rate is exceeded.

The possible values are:

drop—Drops the packet.

policed-dscp-transmit—Remarks the packet DSCP. The remarking is

configured by the qos map policed-dscp command.

Default Usage

Command Mode

Policy-map Class Configuration mode.

—Specifies the average traffic rate (CIR) in kbits per

—Specifies the normal burst size (CBS) in bytes.

[exceed-action