Cisco 300 Series Cli Manual page 622

Stackable managed switches

Hide thumbs Also See for 300 Series:

Table of Contents

IPv6 Commands

OL-32830-01 Command Line Interface Reference Guide

User Guidelines

Use this command to validate the IPv6 status of an interface and its configured

addresses. This command also displays the parameters that IPv6 uses for

operation on this interface and any configured features.

If the interface's hardware is usable, the interface is marked up.

If you specify an optional interface identifier, the command displays information

only about that specific interface. For a specific interface, you can enter the prefix

keyword to see the IPv6 neighbor discovery (ND) prefixes that are configured on

the interface.

Example 1. The show ipv6 interface command displays information about the

specified interface:

switchxxxxxx#

show ipv6 interface vlan 1

VLAN 1 is up/up

IPv6 is enabled, link-local address is FE80::0DB8:12AB:FA01

Global unicast address(es):

Ipv6 Global Address

2000:0DB8::2/64 (ANY)

2000:0DB8::2/64

2000:1DB8::2011/64

Joined group address(es):

FF02::1:FF11:6770

MTU is 1500 bytes

ICMP error messages limited interval is 100ms; Bucket size is 10 tokens

ND DAD is enabled, number of DAD attempts: 1

ND reachable time is 30000 milliseconds

Stateless autoconfiguration is enabled.

MLD Version is 2

Field Descriptions: