Absolute - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
4
133
To ensure that the time range entries take effect at the desired times, the software
clock should be set by the user or by SNTP. If the software clock is not set by the
user or by SNTP, the time range ACEs are not activated.
The user cannot delete a time-range that is bound to any features.
When a time range is defined, it can be used in the following commands:
•
dot1x port-control
•
power inline
•
operation time
•
permit (IP)
•
deny (IP)
•
permit (IPv6)
•
deny (IPv6)
•
permit (MAC)
•
deny (MAC)
Example
switchxxxxxx(config)# time-range http-allowed
console(config-time-range)#periodic mon 12:00 to wed 12:00
4.12
absolute
Use the absolute Time-range Configuration mode command to specify an
absolute time when a time range is in effect. Use the no form of this command to
remove the time limitation.
Syntax
start hh:mm day month year
absolute
start
no absolute
end hh:mm day month year
absolute
end
no absolute
OL-32830-01 Command Line Interface Reference Guide
ACL Commands
Advertisement
Table of Contents
