Dot1X Timeout Silence-Period - Cisco 300 Series Cli Manual

Stackable managed switches

Hide thumbs Also See for 300 Series:

Table of Contents

Default Configuration

The default timeout period is 30 seconds.

Command Mode

Interface (Ethernet) Configuration mode

User Guidelines

The actual timeout period can be determined by comparing the value specified by

this command to the result of multiplying the number of retries specified by the

radius-server retransmit

The following example sets the time interval between retransmission of packets to

the authentication server to 3600 seconds.

switchxxxxxx(config)#

switchxxxxxx(config-if)#

2.23 dot1x timeout silence-period

To set the authentication silence time, use the dot1x timeout silence-period

command in Interface Configuration mode. The silence time is the number of

seconds that if an authorized client does not send traffic during this period, the

client is changed to unauthorized

To return to the default setting, use the no form of this command.

dot1x timeout silence-period

no dot1x timeout silence-period

—Specifies the silence interval in seconds. The valid range is 60 -

command by the timeout period specified by the

command, and selecting the lower of the two values.

interface gi11

dot1x timeout server-timeout

OL-32830-01 Command Line Interface Reference Guide

802. 1 X Commands