Bridge Multicast Source Group - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
5
149
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Before defining forbidden ports, the Multicast group should be registered.
You can execute the command before the VLAN is created.
Example
The following example registers IP address 239.2.2.2, and forbids the IP address
on port gi 1 4 within VLAN 8.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
gi14
5.7
bridge multicast source group
To register a source IP address - Multicast IP address pair to the bridge table, and
statically add or remove ports to or from the source-group, use the bridge
multicast source group Interface (VLAN) Configuration mode command. To
unregister the source-group-pair, use the no form of this command.
Syntax
bridge multicast source
{ethernet interface-list | port-channel port-channel-list}]
no bridge multicast source
Parameters
•
ip-address—Specifies the source IP address.
•
ip-multicast-address—Specifies the group IP Multicast address.
•
add—(Optional) Adds ports to the group for the specific source IP address.
•
remove—(Optional) Removes ports from the group for the specific source
IP address.
interface vlan 8
bridge multicast ip-address 239.2.2.2
bridge multicast forbidden ip-address 239.2.2.2 add
ip-address
ip-multicast-address [[add | remove]
group
ip-address
group
OL-32830-01 Command Line Interface Reference Guide
Address Table Commands
ip-multicast-address
Advertisement
Table of Contents
