Ip Arp Inspection Logging Interval - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
13
333
•
name
—Specifies the static ARP binding list name.
Default Configuration
No static ARP binding list assignment exists.
Command Mode
Global Configuration mode
Example
The following example assigns the static ARP binding list Servers to VLAN 37.
switchxxxxxx(config)#
13.27 ip arp inspection logging interval
Use the ip arp inspection logging interval Global Configuration mode command to
set the minimum time interval between successive ARP SYSLOG messages. Use
the no form of this command to restore the default configuration.
Syntax
ip arp inspection logging interval {
no ip arp inspection logging interval
Parameters
•
seconds
—Specifies the minimum time interval between successive ARP
SYSLOG messages. A 0 value means that a system message is
immediately generated. (Range: 0–86400)
•
infinite—Specifies that SYSLOG messages are not generated.
Default Configuration
The default minimum ARP SYSLOG message logging time interval is 5 seconds.
Command Mode
Global Configuration mode
ip arp inspection list assign
seconds |
infinite}
OL-32830-01 Command Line Interface Reference Guide
DHCP Snooping Commands
37 servers
Advertisement
Table of Contents
