Lldp Med Notifications Topology-Change - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Link Layer Discovery Protocol (LLDP) Commands
OL-32830-01 Command Line Interface Reference Guide
Example
The following example enables LLDP MED with the location TLV on gi 1 3.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
30.7 lldp med notifications topology-change
To enable sending LLDP MED topology change notifications on a port, use the lldp
med notifications topology-change Interface (Ethernet) Configuration mode
command. To restore the default configuration, use the no form of this command.
Syntax
lldp med notifications topology-change
no lldp med notifications topology-change
Parameters
•
enable—Enables sending LLDP MED topology change notifications.
•
disable—Disables sending LLDP MED topology change notifications.
Default Configuration
Disable is the default.
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example enables sending LLDP MED topology change notifications
on
2.
gi1
switchxxxxxx(config)#
switchxxxxxx(config-if)#
interface gi13
lldp med enable location
{enable | disable}
interface gi12
lldp med notifications topology-change enable
30
650
Advertisement
Table of Contents
