Lldp Med Notifications Topology-Change - Cisco 300 Series Cli Manual

Small business 300 series managed switches command line interface guide release 1.3

Hide thumbs Also See for 300 Series:

Table of Contents

Link Layer Discovery Protocol (LLDP) Commands

78-21075-01 Command Line Interface Reference Guide

tlv—Specifies the TLV that should be included. Available TLVs are:

network-policy, location, and poe-pse, inventory. The capabilities TLV is

always included if LLDP-MED is enabled.

disable - disable LLDP MED on the port

Default Configuration

Enabled with network-policy TLV

Command Mode

Interface Configuration (Ethernet) mode

The following example enables LLDP MED with the location TLV on gi3.

switchxxxxxx(config)#

switchxxxxxx(config-if)#

37.15 lldp med notifications topology-change

Use the lldp med notifications topology-change Interface Configuration (Ethernet)

mode command to enable sending LLDP MED topology change notifications on a

port. Use the no form of this command to restore the default configuration.

lldp med notifications topology-change

no lldp med notifications topology-change

enable—Enables sending LLDP MED topology change notifications.

disable—Disables sending LLDP MED topology change notifications.

Default Configuration

Disable is the default.

interface gi3

lldp med enable location

{enable | disable}