Bridge Multicast Ipv6 Forbidden Ip-Address - Cisco 300 Series Cli Manual

Small business 300 series managed switches command line interface guide release 1.3

Hide thumbs Also See for 300 Series:

Table of Contents

Default Configuration

No Multicast addresses are defined.

The default option is add.

Command Mode

Interface Configuration (VLAN) mode

User Guidelines

To register the group in the bridge database without adding or removing ports or

port channels, specify the ipv6-multicast-address parameter only.

Static Multicast addresses can be defined on static VLANs only.

You can execute the command before the VLAN is created.

Example 1 - The following example registers the IPv6 address to the bridge table:

switchxxxxxx(config)#

switchxxxxxx(config-if)#

Example 2 - The following example registers the IPv6 address and adds ports

switchxxxxxx(config)#

switchxxxxxx(config-if)#

29.11 bridge multicast ipv6 forbidden ip-address

Use the bridge multicast ipv6 forbidden ip-address Interface Configuration (VLAN)

mode command to forbid adding or removing a specific IPv6 Multicast address to

or from specific ports. To restore the default configuration, use the no form of this

interface vlan

bridge multicast ipv6 ip-address

interface vlan

bridge multicast ipv6 ip-address

78-21075-01 Command Line Interface Reference Guide

Address Table Commands

FF00:0:0:0:4:4:4:1