Lldp Med Network-Policy (Interface) - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
37
Link Layer Discovery Protocol (LLDP) Commands
•
value
dscp
—DSCP value to be used for the specified application.
Default Configuration
No network policy is defined.
Command Mode
Global Configuration mode
User Guidelines
Use the lldp med network-policy Interface Configuration command to attach a
network policy to a port.
Up to 32 network policies can be defined.
Example
This example creates a network policy for the voice-signally application and
attaches it to port 1. LLDP packets sent on port 1 will contain the information
defined in the network policy.
switchxxxxxx
(config)# lldp med network-policy 1 voice-signaling vlan 1
vlan-type untagged up 1 dscp 2
switchxxxxxx(config)#
interface gi1
switchxxxxxx(config-if)#
lldp med network-policy add
1
37.18 lldp med network-policy (interface)
Use the lldp med network-policy Interface Configuration (Ethernet) mode
command to attach or remove an LLDP MED network policy on a port. Network
policies are created in
lldp med network-policy
(global).
Use the no form of this command to remove all the LLDP MED network policies
from the port.
Syntax
{add | remove} number
lldp med network-policy
number
no lldp med network-policy
616
78-21075-01 Command Line Interface Reference Guide
Advertisement
Table of Contents
