Logging Aggregation Aging-Time - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
20
Syslog Commands
no logging aggregation on
Parameters
N/A
Default Configuration
Enabled.
Command Mode
Global Configuration mode
Example
To turn off aggregation of SYSLOG messages:
switchxxxxxx(config)# no logging aggregation on
20.11 logging aggregation aging-time
Use the logging aggregation aging-time Global Configuration mode command to
configure the aging time of the aggregated SYSLOG messages. The SYSLOG
messages are aggregated during the time interval set by the aging-time
parameter. Use the no form of this command to return to the default.
Syntax
sec
logging aggregation aging-time
no logging aggregation aging-time
Parameters
sec
aging-time
—Aging time in seconds (Range: 15–3600)
Default Configuration
300 seconds.
Command Mode
Global Configuration mode
296
78-21075-01 Command Line Interface Reference Guide
Advertisement
Table of Contents
