Show Snmp Groups - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
12
204
notifyview
If
is not specified, the notify view is not defined.
readview
If
is not specified, all objects except for the community-table and
SNMPv3 user and access tables are available for retrieval.
writeview
If
is not specified, the write view is not defined.
Command Mode
Global Configuration mode
User Guidelines
The group defined in this command is used in
the group. These users are then automatically mapped to the views defined in this
command.
The command logical key is (groupname, snmp-version, security-level). For
snmp-version v1/v2 the security-level is always noauth.
Example
The following example attaches a group called
the encrypted security level to the group, and limits the access rights of a view
user-view
called
to read-only. User
tom
user
has the rights assigned in
switchxxxxxx(config)#
switchxxxxxx(config)# snmp-server user tom user-group v3
12.7
show snmp groups
Use the show snmp groups Privileged EXEC mode command to display the
configured SNMP groups.
Syntax
groupname
show snmp groups [
Parameters
groupname—Specifies the group name. (Length: 1–30 characters)
Network Management Protocol (SNMP) Commands
tom
is then assigned to
user-view
user-group
snmp-server group
]
78-21075-01 Command Line Interface Reference Guide
snmp-server user
to map users to
user-group
to SNMPv3, assigns
user-group
.
v3 priv read
. So that
user-view
Advertisement
Table of Contents
