Radius-Server Key - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
18
274
If a parameter was not set in one of the above commands, the default for that
command is used. For example, if a timeout value was not set in the current
command or in
radius-server
is used.
The default usage type is all.
Command Mode
Global Configuration mode
User Guidelines
To specify multiple hosts, this command is used for each host.
The source parameter address type (IPv4 or IPv6) must be the same as that of the
host IP address type.
Example
The following example specifies a RADIUS server host with IP address
192.168.10.1, authentication request port number 20, and a 20-second timeout
period.
switchxxxxxx(config)#
18.2
radius-server key
Use the radius-server key Global Configuration mode command to set the
authentication and encryption key for RADIUS communications between the
device and the RADIUS daemon.
Use the no form of this command to restore the default configuration.
Syntax
key-string
radius-server key [
encrypted radius-server key [encrypted-
no radius-server key
Parameters
•
key-string—Specifies the authentication and encryption key for all RADIUS
communications between the device and the RADIUS server. This key must
timeout, the default timeout for
192.168.10.1
radius-server host
]
key-string
78-21075-01 Command Line Interface Reference Guide
RADIUS Commands
radius-server timeout
20
auth-port
timeout
]
20
Advertisement
Table of Contents
