Permit ( Mac ) - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
48
ACL Commands
deny (MAC)
commands. The
service-acl input
command is used to attach this ACL
to an interface.
Use the no form of this command to remove the access list.
Syntax
acl-name
mac access-list extended
acl-name
no mac access-list extended
Parameters
acl-name—Specifies the name of the MAC ACL (Range: 1–32 characters).
Default Configuration
No MAC access list is defined.
Command Mode
Global Configuration mode
User Guidelines
A MAC ACL is defined by a unique name. IPv4 ACL, IPv6 ACL, MAC ACL or policy
maps cannot have the same name.
Example
switchxxxxxx(config)# mac access-list extended server1
switchxxxxxx(config-mac-al)# permit 00:00:00:00:00:01 00:00:00:00:00:ff any
48.8
permit ( MAC )
Use the permit command in MAC Access List Configuration mode to set permit
conditions (ACEs) for a MAC ACL.
Syntax
permit
{any | source source-wildcard} {any | destination destination-wildcard} [eth-type 0 | aarp |
amber | dec-spanning | decnet-iv | diagnostic | dsm | etype-6000] [vlan vlan-id] [cos cos cos-wildcard]
782
78-21075-01 Command Line Interface Reference Guide
Advertisement
Table of Contents
