Lldp Notifications; Lldp Notifications Interval - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
37
610
37.11 lldp notifications
Use the lldp notifications Interface Configuration (Ethernet) mode command to
enable/disable sending LLDP notifications on an interface. Use the no form of this
command to restore the default configuration.
Syntax
{enable | disable}
lldp notifications
no lldp notifications
Parameters
•
enable—Enables sending LLDP notifications.
•
disable—Disables sending LLDP notifications.
Default Configuration
Disabled.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example enables sending LLDP notifications on gi5.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
37.12 lldp notifications interval
Use the lldp notifications interval Global Configuration mode command to
configure the maximum transmission rate of LLDP notifications. Use the no form of
this command to return to the default.
Syntax
lldp notifications interval
no lldp notifications interval
Link Layer Discovery Protocol (LLDP) Commands
interface gi5
lldp notifications
seconds
78-21075-01 Command Line Interface Reference Guide
enable
Advertisement
Table of Contents
