Interface Ip; Ip Helper-Address - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
IP Addressing Commands
78-21075-01 Command Line Interface Reference Guide
43 13 interface ip
Use the interface ip Global Configuration mode command to enter the IP Interface
Configuration mode.
This command can only be used when the device is in Router mode.
Syntax
interface ip
-address
Parameters
ip-address—Specifies one of the IP addresses of the device.
Command Mode
Global Configuration mode
User Guidelines
To use this command, you must put the switch into routing mode using
Example
The following example enters the IP interface configuration mode.
switchxxxxxx(config)#
switchxxxxxx(config-ip)#
43 14 ip helper-address
Use the ip helper-address Global Configuration mode command to enable the
forwarding of UDP Broadcast packets received on an interface to a specific
(helper) address. Use the no form of this command to disable the forwarding of
broadcast packets to a specific (helper) address.
This command can only be used when the device is in Router mode.
Syntax
ip-interface | all} address
ip helper-address {
no ip helper-address {
interface ip
192.168.1.1
ip-interface | all} address
udp-port-list
[
]
43
set
system.
719
Advertisement
Table of Contents
