Cisco 300 Series Cli Manual page 787

Small business 300 series managed switches command line interface guide release 1.3

Hide thumbs Also See for 300 Series:

Table of Contents

ACL Commands

78-21075-01 Command Line Interface Reference Guide

time-range-name—Specifies the name for the time range. (Range: 1–32

Default Configuration

No time range is defined

Command Mode

Global Configuration mode

User Guidelines

After adding the name of a time range with this command, use the

commands to actually configure the time-range. Multiple periodic

commands are allowed in a time range. Only one absolute command is allowed.

If a time-range command has both absolute and periodic values specified, then

the periodic items are evaluated only after the absolute start time is reached, and

are not evaluated again after the absolute end time is reached.

All time specifications are interpreted as local time.

To ensure that the time range entries take effect at the desired times, the software

clock should be set by the user or by SNTP. If the software clock is not set by the

user or by SNTP, the time range ACEs are not activated.

The user cannot delete a time-range that is bound to any features, such as ACLs.

When a time range is defined, it can be used in the following commands:

dot1x port-control

power inline

permit (IPv6)

permit (MAC)