Back-Pressure; Port Jumbo-Frame - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Ethernet Configuration Commands
78-21075-01 Command Line Interface Reference Guide
23.11 back-pressure
Use the back-pressure Interface Configuration (Ethernet) mode command to
enable back pressure on a specific interface. Use the no form of this command to
disable back pressure.
Syntax
back-pressure
no back-pressure
Default Configuration
Back pressure is disabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Back-pressure cannot be enabled when EEE is enabled.
Example
The following example enables back pressure on port
(config)#
switchxxxxxx
switchxxxxxx
(config-if)#
23.12 port jumbo-frame
Use the port jumbo-frame Global Configuration mode command to enable jumbo
frames on the device. Use the no form of this command to disable jumbo frames.
Syntax
port jumbo-frame
no port jumbo-frame
interface gi5
back-pressure
23
5.
gi
355
Advertisement
Table of Contents
