Lldp Med Location - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Link Layer Discovery Protocol (LLDP) Commands
78-21075-01 Command Line Interface Reference Guide
Parameters
interface-id—Specifies a port ID.
Default Configuration
If no interface is specified, the default is to clear the LLDP table for all ports.
Command Mode
Privileged EXEC mode
Example
switchxxxxxx
# clear lldp table gi1
37.21 lldp med location
Use the lldp med location Interface Configuration (Ethernet) mode command to
configure the location information for the LLDP Media Endpoint Discovery (MED)
for a port. Use the no form of this command to delete location information for a
port.
Syntax
{{coordinate data} | {civic-address data} | {ecs-elin data}}
lldp med location
no lldp med location
Parameters
•
coordinate
data
hexadecimal format.
•
civic-address
hexadecimal format.
•
data
ecs-elin
—Specifies the location data as an Emergency Call Service
Emergency Location Identification Number (ECS ELIN) in hexadecimal
format.
•
data—Specifies the location data in the format defined in ANSI/TIA 1057:
dotted hexadecimal data: Each byte in a hexadecimal character string is
two hexadecimal digits. Bytes are separated by a period or colon. (Length:
coordinate: 16 bytes. Civic-address: 6-160 bytes. Ecs-elin: 10-25 bytes)
{coordinate | civic-address | ecs-elin}
—Specifies the location data as coordinates in
data
—Specifies the location data as a civic address in
37
619
Advertisement
Table of Contents
