Show Lacp - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
40
670
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example assigns a long administrative LACP timeout to gi6.
switchxxxxxx(config)# interface gi6
switchxxxxxx(config-if)# lacp timeout long
40.4
show lacp
Use the show lacp EXEC mode command to display LACP information for all
Ethernet ports or for a specific Ethernet port.
Syntax
interface-id [parameters | statistics | protocol-state
show lacp
Parameters
•
interface-id —Specify an interface ID. The interface ID must be an Ethernet
port
•
parameters—Displays parameters only.
•
statistics—Displays statistics only.
•
protocol-state—Displays protocol state only.
Command Mode
EXEC mode
Example
The following example displays LACP information for gi1.
switchxxxxxx# show lacp ethernet
gi
Port
1 LACP parameters:
Actor
Link Aggregation Control Protocol (LACP) Commands
gi
1
78-21075-01 Command Line Interface Reference Guide
]
Advertisement
Table of Contents
