Dot1X System-Auth-Control; Dot1X Port-Control - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
22
320
Example
The following example sets the 802.1X authentication mode to RADIUS server
authentication. If no response is received, no authentication is performed.
switchxxxxxx(config)#
22.2
dot1x system-auth-control
Use the dot1x system-auth-control Global Configuration mode command to
enable 802.1X globally. Use the no form of this command to restore the default
configuration.
Syntax
dot1x system-auth-control
no dot1x system-auth-control
Parameters
N/A
Default Configuration
Disabled.
Command Mode
Global Configuration mode
Example
The following example enables 802.1X globally.
switchxxxxxx(config)#
22.3
dot1x port-control
Use the dot1x port-control Interface Configuration (Ethernet) mode command to
enable manual control of the port authorization state. Use the no form of this
command to restore the default configuration.
aaa authentication dot1x default radius none
dot1x system-auth-control
78-21075-01 Command Line Interface Reference Guide
802. 1 X Commands
Advertisement
Table of Contents
