Qos Trust (Interface) - Cisco 300 Series Cli Manual

Small business 300 series managed switches command line interface guide release 1.3

Hide thumbs Also See for 300 Series:

Table of Contents

Quality of Service (QoS) Commands

78-21075-01 Command Line Interface Reference Guide

For an inter-QoS domain boundary, configure the port to the DSCP-trusted state

and apply the DSCP-to-DSCP-mutation map if the DSCP values are different in the

QoS domains.

The following example configures the system to the DSCP trust state.

switchxxxxxx(config)#

49.33 qos trust (Interface)

Use the qos trust Interface Configuration (Ethernet, Port-channel) mode command

to enable port trust state while the system is in the basic QoS mode. Use the no

form of this command to disable the trust state on each port.

no qos trust

Default Configuration

Each port is enabled while the system is in basic mode.

Command Mode

Interface Configuration (Ethernet, Port-channel) mode

The following example configures gi15 to the default trust state.

switchxxxxxx(config)#

switchxxxxxx(config-if)#

qos trust dscp