Lldp Optional-Tlv 802.1 - Cisco 300 Series Cli Manual

Small business 300 series managed switches command line interface guide release 1.3

Hide thumbs Also See for 300 Series:

Table of Contents

Link Layer Discovery Protocol (LLDP) Commands

78-21075-01 Command Line Interface Reference Guide

tlv—Specifies the TLVs to be included. Available optional TLVs are: 802.1,

port-desc, sys-name, sys-desc, sys-cap, 802.1, 802.3-mac-phy, 802.3-lag,

802.3-max-frame-size.

none—Clear all optional TLVs from the interface

If the 802.1 protocol is selected, see the command below.

Default Configuration

No optional TLV is transmitted.

Command Mode

Interface Configuration (Ethernet) mode

The following example specifies that the port description TLV is transmitted on

switchxxxxxx(config)#

switchxxxxxx(config-if)#

lldp optional-tlv 802.1

Use the lldp optional-tlv Interface Configuration mode command to specify which

optional TLVs to transmit. Use the no form of this command to revert to the default

lldp optional-tlv 802.1 pvid - The PVID is advertised.

no lldp optional-tlv 802.1 pvid - The PVID is not advertised

lldp optional-tlv 802.1 ppvid

advertised. The PPVID is the PVID that is used depending on the packet's protocol.

lldp optional-tlv 802.1 ppvid

lldp optional-tlv 802.1 vlan

interface gi2

lldp optional-tlv port-desc

- The Protocol Port VLAN ID (PPVID) is

remove ppvid

- The PPVID is not advertised.

remove vlan-id

is advertised.

is not advertised.