Macro - Cisco 300 Series Cli Manual

Small business 300 series managed switches command line interface guide release 1.3

Hide thumbs Also See for 300 Series:

Table of Contents

Macro Commands

78-21075-01 Command Line Interface Reference Guide

and SPEED must be provided by the user. The #macro keywords command

enables the user to receive help for the macro as shown in Example 3.

switchxxxxxx(config) #

Enter macro commands one per line. End with the character '@'.

duplex $DUPLEX

no negotiation

speed $SPEED

#macro keywords $DUPLEX $SPEED

Example 3 -The following example shows how to display the keywords using the

help character ? (as defined by the macro keywords command above) and then

run the macro on the port. The #macro keywords command entered in the macro

definition enables the user to receive help for the macro, as shown after the words

switchxxxxxx(config-if)#interface gi1

switchxxxxxx(config-if)#macro apply duplex ?

Keyword to replace with value e.g. $DUPLEX, $SPEED

switchxxxxxx(config-if)#macro apply duplex $DUPLEX ?

First parameter value

switchxxxxxx(config-if)#macro apply duplex $DUPLEX full $SPEED ?

Second parameter value

switchxxxxxx(config-if)#macro apply duplex $DUPLEX full $SPEED 100

macro

Use the macro apply/trace Interface Configuration command to either:

Apply a macro to an interface without displaying the actions being

Apply a macro to the interface while displaying the actions being

macro name duplex